10
Two fullrange speakers and one subwoofer to
CA41.
Rear subwoofer Rear or front speakers
Filter settings A/B Channels
The subwoofer should be connected to channel A/
B in bridge mode.The Grand Bass mode can now
be used for the subwoofer.
Set the HPF-filter switch to ON-position. Adjust the
filter setting to 25-40 Hz.
Set the LPF-filter switch to ON-position and the
Multiply swich to x1. Adjust the frequency setting to
70-90 Hz.
Filter settings C/D Channels
With the HPF-filter in OFF position the amplifier
allows the speakers to play fullrange. If you for
some reason want to limit the low bass
reproduction switch on the HPF-filter. The typical
setting is then around 60 – 80 Hz.
HPF
Off On
50Hz 220Hz
15Hz
500Hz
Multiply
x1 x10
80/800Hz
Off On
200/2(k)Hz
50/500Hz
500/5(k)Hz
LPF
220/2(k)Hz
CA41
Speaker wiring CA 41
Four fullrange speakers to CA41. One pair in
front and one pair in rear.
Rear speakers Front speakers
Filter settings A/B Channels
With the HPF-filter in OFF position the amplifier
allows the speakers to play fullrange. If you for
some reason want to limit the low bass
reproduction switch on the HPF-filter. The typical
setting is then around 60 – 80 Hz.
The LPF-filter switch should be in OFF-position
Multiply
x1 x10
80/800Hz
Off On
200/2(k)Hz
50/500Hz
500/5(k)Hz
LPF
HPF
50/500Hz 220/2(k)Hz
15/150Hz
500/5(k)Hz
Off On
Multiply
x1 x10
HPF
Off On
50Hz 220Hz
15Hz
500Hz
Filter settings C/D Channels
With the HPF-filter in OFF position the amplifier
allows the speakers to play fullrange. If you for
some reason want to limit the low bass
reproduction switch on the HPF-filter. The typical
setting is then around 60 – 80 Hz.
HPF
50/500Hz
15/150Hz
500/5(k)Hz
Off On
Multiply
x1 x10
To Next Page
Loading...
