To Next PageTo Next Page
Need help?Do you have a question about the DMG RAFFAELLO and is the answer not in the manual?
Details for flush mounting installation of the display unit.
Instructions for panels with welded pins and D13 Screen frontal mounting.
Frontal mounting instructions specific to the DZ1 Screen.
Instructions for wiring position and direction inputs to the display.
Wiring details for Pitagora 4.0, DMG serial, and DEUM Encoder.
Wiring considerations for other controller types and serial connections.
Configuration for 1 Wire per Floor and 1 Wire per Segment wiring.
Wiring setup for service messages on a parallel display.
Wiring setup for service messages on a CAN serial display.
Navigation keys and general display settings including language.
Settings for direction arrows and next direction arrow behavior.
Configuration of CAN BUS transmission speed.
Setup for intermediate floors visualization and floor offset.
Settings for first visualization, common input, and arrow types.
Settings for auxiliary signals, floor change delay, and energy saving.
Configuration of font, flat style colors, and gradient styles.
Settings for floor symbols, arrows, signalizations, and display orientation.
Setup for service message inputs, auxiliary signals, and factory reset.
General