•Screen Dormant: OFF / 1 MIN / 3 MIN
Adjust the time of screen dormant
•Video Encode: H264 / 265
Adjust the video encode of video.H265 is the newest video encode,but H264 has better
compatibility.
•Video Frequency: 50HZ / 60HZ
Adjust the video frequency of video.
•USB Mode
Connects the USB cable, selects USB in the settings, pop-up window: USB storage, USB
camera, USB video three modes.
•Key Voice: OFF / ON
Turn On/Off the key voice
•Speaker： MUTE / LOW / MIDDLE / HIGH
Adjust the sound strength of speaker
•Boot Sound: OFF / ON
Turn On/Off the voice of boot
•Stream Media: OFF / ON
When the stream media is "on", the default full-screen is rear camera display while
starting the car engine, and when the streaming media is "off", the default full-screen is
front camera display while starting the car engine.
•Language: English /中文简体 / 中文繁体 / 日本语 / русский / ا لعربية
/Destsch
•Time Setting
Press up and down to adjust the date and time.
[Note] Please set the correct date and time before using the camera to insure they are
accurate on the accident recording used as evidence.After setting, please turn off the
dash cam. The date and time setting is completed
•Format SD
Format the TF card.
[Note] Please format the Micro SD card before use
•Reset
Reset all the setting.
•About
Software version
-9-
To Next Page