Need help?Do you have a question about the Dnepr MT10 and is the answer not in the manual?
Covers procedures for removing and installing engine components like cylinder head, piston, rings, etc.
Focuses on repairs for engine units, including crank, connecting rod, cylinder, piston, and valve train.
Outlines the process for adjusting and running in a repaired engine, including carburetor tuning.
Details the steps for disassembling and reassembling the gear box, including clutch release and speedometer drive.
Covers specifications, winding data, and checks for the f414 generator.
Provides specifications for the f424 generator used in MT10 models.
Details specifications, winding data, checking, and adjusting the PP302 regulator.
Covers ignition system components like breaker, coil, spark plugs, and wiring diagrams.
General| Displacement | 649 cc |
|---|---|
| Starting System | Kickstart |
| Front Suspension | Telescopic fork |
| Front Brake | Drum |
| Rear Brake | Drum |
| Transmission | 4-speed manual |
| Final Drive | Shaft |
| Fuel Capacity | 19 L |
| Rear Suspension | Swingarm with twin shock absorbers |
| Maximum Speed | 105 km/h |
| Torque | 5.0 kgf⋅m (49 N⋅m; 36 lbf⋅ft) at 3800 rpm |
To Next Page
