Camera Settings
Each mode has a unique set of settings. See the description below.
Video Recording: First Settings Page
Accessed by pressing[ ] once.
Cannot be changed.
Shows WDR processing is enabled.
Changes the video resolution. Lower the resolution for
smaller file sizes but this reduces video quality.
Sets the brightness /darkness of the video.
Video too bright? Set between -1 to -3.
Video too dark? +1 to +3.
Sets the white balance.
Recommended setting: Auto.
Switches the microphone on/off.
Can be used during recording by pressing button [
Imprints the time and date on the recorded video.
Can be set to 2, 3 or 5 minutes. Video recordings of
the selected length will be recorded onto the memory
card. When the memory card is full, the oldest files
will be overwritten, excluding locked clips. Turing off
loop recording will prevent the camera from writing
new files when the memory card is filled.
Measures shock forces. The settings from “low to
high” determine the amount of force needed to lock
the file from being overwritten.
Recommended setting: Low.
Settings pages are accessible:
System Settings
The menu settings can be switched by pressing [ ].
If you move the cursor before pressing [ ], you must exit and try again.
Note: Press [ ]to enter the camera settings when recording.
To Next Page
Loading...