Headlight Low/High Beam Selector Switch
Push the multifunction lever forward to switch the
headlights to HIGH and pull toward yourself (normal
position) to return to LOW beam.
Flash to Pass (Optical Horn)
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever fully toward your-
self. This will cause the headlights to turn on at high
beam and remain on until the lever is released.
Windshield Wiper and Washer
The wipers and washers are operated by a switch within
the Multifunction Lever. Rotate the end of the lever to
select the desired wiper speed.
NOTE: Always remove any build-up of snow that
prevents the windshield wiper blades from returning to
the OFF position. If the windshield wiper switch is
turned OFF and the blades cannot return to the OFF
position, damage to the wiper motor may occur.
Windshield Wipe Wash Control
1 - Multifunction Lever — Mist, Front Wiper and Washer
2 - Intermittent, Low and High Wiper
3 - Rotary Ring — Rear Wiper and Washer
4 - Headlamp Low and High Beam and Flash to Pass
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 163
3
To Next Page
Loading...
