CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
Front Park/Turn Signal and Side Marker Lights
1. Access to change the Park/Turn Signal or Side Marker
bulb is from the rear of the headlight housing.
2. Twist the turn signal or Side Marker socket to remove
from the headlight module and pull bulb from socket.
3. Replace the bulb and reinstall socket.
Fog Lights
NOTE: Access to the lights through the lower fascia
cutout is limited. We recommend you access the lights by
turning the steering wheel to allow access and remove
the inner fender shield.
1. Rotate the bulb’s electrical connector
1
⁄
4
turn counter-
clockwise and remove it from the fog light housing.
2. Remove the bulb from the connector socket and install
the replacement bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
454 MAINTAINING YOUR VEHICLE
To Next Page
Loading...
