EasyManua.ls Logo

Dodge CHALLENGER 2021 - Page 20

Dodge CHALLENGER 2021
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 GETTING TO KNOW YOUR INSTRUMENT PANEL
c. Press and hold the “OK button on the
steering wheel to activate “Line Lock”.
d. While still holding down the “OK” button,
fully release the brake pedal and apply
the gas pedal to begin the burnout.
Front brakes remain engaged.
Feature is exited when either the gas
pedal is lifted, the brake pedal is
pressed, the “OK” button is released, or
the max number of tire revolutions is
attained.
4. TransBrake™ Launch
Initial Conditions:
i) Odometer greater than
500 miles(805 kilometers).
b) Vehicle must have Drag mode
enabled.
c) Engine is running.
d) Vehicle speed is at 0 mph (0 km/h).
e) Steering wheel is straight.
f) Vehicle is in “DRIVE” in 1st gear.
g) Radiator coolant temp is less
than250°F (121°C).
h) Line Lock/Launch Control and
Cruise Control are not engaged.
i) All doors are closed.
j) Parking brake is not set.
k) Vehicle is on level ground.
Staging The Car
i) At or near Pre-Staging, pull and hold
both paddle shifters back simulta-
neously.
b) Push and hold the brake pedal
firmly with left foot.
c) Slowly apply steady throttle to a
pre-staging engine speed (between
1,500-2,350 RPM).
NOTE:
Torque Reserve will be activated at 950 RPM:
as a result engine vibration and exhaust tone
will change noticeably.
d) Slightly release brake pressure to
roll up to the stage lights while main-
taining throttle and engine speed.
e) Stop at the full stage light and
ensure vehicle speed is 0 mph
(0 km/h).
f) Release one shift paddle at or
above 1,500 RPM with zero wheel
speed.
g) Remove foot from brake pedal.
h) TransBrake™ is fully engaged/
locked when brake pedal is
released and reaches the up-stop.
NOTE:
The Electronic Stability Control (ESC) system
holds brake pressure, and the transmission
locks to hold driveline torque.
TransBrake™ Engaged/Locked
i) Adjust throttle to target launch
engine speed between idle -
2,350 RPM.
TransBrake™ Release/Launch
j) Vehicle launches once the last
paddle shifter is released.
NOTE:
If the engine speed rises above 2,350 RPM the
TransBrake™ feature will cancel.
21_LALD_SU_EN_USC_t.book Page 18

Table of Contents

Other manuals for Dodge CHALLENGER 2021

Related product manuals