26
MULTIMEDIA
UCONNECT SETTINGS
The Uconnect system uses a combination of
buttons on the touchscreen and buttons on the
faceplate located on the center of the
instrument panel. These buttons allow you to
access and change the Customer
Programmable Features. Many features can
vary by vehicle.
Buttons on the faceplate are located below
and/or beside the Uconnect system in the
center of the instrument panel. In addition,
there is a Scroll/Enter control knob located on
the right side. Turn the control knob to scroll
through menus and change settings. Push the
center of the control knob one or more times to
select or change a setting.
Your Uconnect system may also have Screen
Off and Mute buttons on the faceplate.
Push the Screen Off button on the faceplate to
turn off the Uconnect screen. Push the button
again or tap the screen to turn the screen on.
Press the Back Arrow button to exit out of a
Menu or certain option on the Uconnect system.
CUSTOMER PROGRAMMABLE FEATURES
For the Uconnect 4/4C/4C NAV With 8.4-inch
Display
Press the Apps button, then press the
Settings button on the touchscreen to display
the menu setting screen. In this mode the
Uconnect system allows you to access
programmable features.
NOTE:
All settings should be changed with the igni-
tion in the ON/RUN position.
Only one area of the touchscreen may be
selected at a time.
When making a selection, press one button on
the touchscreen to enter the desired menu.
Once in the desired menu, press and release
the preferred setting option until a check mark
appears next to the setting, showing that setting
has been selected.
Once the setting is complete, either press the
Back Arrow button on the touchscreen to return
to the previous menu, or press the X button on
the touchscreen to close out of the settings
screen. Pressing the Up or Down Arrow button
on the right side of the screen will allow you to
toggle up or down through the available
settings.
NOTE:
Availability of settings, setting names, and
menu options can vary depending on vehicle
features, equipped Uconnect system, and the
currently installed software.
Units
When the Units button is pressed on the
touchscreen, the system displays the different
measurement options. The selected unit of
measurement will display in the instrument
cluster display and navigation system (if
equipped). The available settings are:
21_LALD_SU_EN_USC_t.book Page 26
To Next Page
Loading...
