MULTIMEDIA 197
Engine Torque
Shows the instantaneous torque.
Oil Pressure (6.4L Only) — If Equipped
Shows the actual engine oil pressure.
Boost Pressure (6.2L Only) — If Equipped
Shows the actual boost pressure.
Gear (Automatic Transmission Only)
Shows the current (or pending) operating
gear of the vehicle.
DYNAMOMETER (DYNO)
Dyno Page
The system will start drawing graphs for Power
and Torque (top chart) and Engine Speed
(bottom chart). The graph will fill to the right side
of the page (based on History time selected).
Once the right side of the page is reached, the
graph will scroll with the right side always being
the most recent recorded sample.
The following options can be selected:
Pressing the STOP button will freeze the
graph. Selecting Play will clear the graph and
restart the process over.
Press the + or – buttons to change the history
of the graph. The selectable options are “30”,
“60”, “90”, or “120” seconds. The graph will
expand or constrict depending on the setting
selected.
Select the “Gear” display setting to turn the
graph gear markers on and off for automatic
transmission vehicles only.
NOTE:
The Gear On/Off feature will only display if your
vehicle is equipped with an Automatic Trans-
mission.
DODGE DRIVE MODES — IF EQUIPPED
PERFORMANCE CONTROL — IF
E
QUIPPED
Your vehicle may be equipped with a
Performance Control feature which allows for
coordinating the operation of various vehicle
systems depending upon the type of driving
behavior desired. The Performance Control
feature is controlled through the Uconnect
system and may be accessed by performing any
of the following:
Pushing the Super Track Pack button on the
instrument panel switch bank.
Selecting “Performance Control” from the
“Apps” menu.
Selecting “Performance Control” from within
the Performance Pages menu.
You will be able to enable, disable, and
customize the functionality of the Launch
Control and Performance Control Set-Up
features within Performance Control.
5
21_LD_OM_EN_USC_t.book Page 197
To Next Page
Loading...
