To Enter The Trunk
With a valid key fob located outside the
vehicle and within 5 ft (1.5 m) of the trunk,
push the button on the right side of appli-
que which is located on the trunk.
Whenever the vehicle is unlocked, you can
enter the trunk by pushing the button on
the right side of the applique.
NOTE:
Please refer to “Keyless Enter-N-Go — Pas-
sive Entry” in “Things To Know Before
Starting” in the Owner's Manual on
www.dodge.com/en/owners/manuals
for fur-
ther information.
KEYLESS ENTER-N-GO — IGNITION
NOTE:
In case the ignition switch does not change with the push of a button, the key fob may
have a low or dead battery. In this situation, a back up method can be used to operate the
ignition switch. Put the nose side of the key fob (side opposite of the Emergency Key)
against the ENGINE ST ART/STOP button and push to operate the ignition switch.
Starting
1. Place the gear selector in P ARK or NEU-
TRAL.
2. While pushing the brake pedal, push the
ENGINE START/STOP button once. If
the engine fails to start, the starter will
disengage automatically after 10 sec-
onds.
3. To stop the cranking of the engine prior
to the engine starting, push the button
again.
Trunk Passive Entry Button
Engine START/STOP Button
GETTING STARTED
19
To Next Page
Loading...
