Setup feature allows you to change the location that
information is displayed within the instrument cluster.
Use the UP
and DOWN arrow buttons to high-
light a screen setup location (i.e., Upper Left, Upper
Right, etc.) then push the RIGHT
arrow button to
select the location and make changes. Push the UP
and DOWN arrow buttons to select the infor-
mation you would like to display in that location (i.e.,
Date, Time, Outside Temp, etc.) and push the RIGHT
arrow button to save the display setting. You can
push the LEFT
arrow button at any time to back
out of a sub-menu selection.
NOTE: The Screen Setup items are only available at
speeds less than 5 MPH (8 km/h). All other menu items
are not active when in Screen Setup. If the vehicle is
shifted into gear, this feature is locked out and the main
screen will display “Screen Setup Unavailable While In
Motion”.
Screen Setup Driver Selectable Items
• Speedometer
Analog 1
Analog 2
Digital 1 (default setting)
Digital 2
• Gear Display
Standard (PRND –/+) (default setting)
Single Character (D)
Word (Drive)
• Upper Left
None
Compass
Outside Temp (default setting)
362 UNDERSTANDING YOUR INSTRUMENT PANEL
To Next Page
Loading...
Need help?
General
