10
The STB HAWK COLLAR will always start in the Run/
Point Mode. To change to the Point-Only Mode, turn the
system on and place the activation magnet to the red dot
on the STB HAWK COLLAR for 1 second and release.
When the Point-Only Mode is selected, the STB HAWK
COLLAR will emit a beep sound. If you want to change to
the Run/Point Mode again, repeat the same procedure by
turning the system on and placing the activation magnet
to the red dot on the STB HAWK COLLAR for 1 second
and release.
In the Run/Point Mode, there will be a double beep every
7 seconds while the dog is running and double beep every
2 seconds when the dog is pointing/stationary.
In the Point-Only Mode, the beeper will remain silent
while the dog is running and a single hawk sound every 2
seconds when the dog is pointing/stationary.
3. Hawk Function
Mode Dog Running Dog Pointing
Run/Point Mode
Double beep
every 7 seconds
Double beep every 2 seconds
Point-Only Mode No Sound
Single hawk sound
every 2 seconds
To Next Page
Loading...
