9
The STB BEEPER COLLAR will always start in the Run/
Point Mode. To change to the Point-Only Mode, turn the
system on and place the activation magnet to the red dot
on the STB BEEPER COLLAR for 1 second and release.
When the Point-Only Mode is selected, the STB BEEPER
COLLAR will emit a beep sound. If you want to change to
the Run/Point Mode again, repeat the same procedure by
turning the system on and placing the activation magnet
to the red dot on the STB BEEPER COLLAR for 1 second
and release.
In the Run/Point Mode, there will be a double beep every
7 seconds while the dog is running and double beep every
2 seconds when the dog is pointing/stationary.
In the Point-Only Mode, the beeper will remain silent while
the dog is running and double beep every 2 seconds when
the dog is pointing/stationary.
2. Beeper Function
Mode Dog Running Dog Pointing
Run/Point Mode
Double beep
every 7 seconds
Double beep every 2 seconds
Point-Only Mode No Sound Double beep every 2 seconds
To Next Page
Loading...
