6. PREPARING A BEVERAGE
6.1 ONE CAPSULE (E. G. LUNGO)
1
Check ifthe watertank contains enough freshdrinking
water. Switch on machine. While machine isheating up, ON
/ OFF icon starts blinking red. Afterapprox. 30seconds, ON /
OFF iconlights up steady green. Machine is ready to use.
2
Adjustdrip tray position. Place cup with correctcup size on
driptray. See 3. "BEVERAGE EXAMPLES" or package.
3
Pullout capsule holder. Make sure rinsing tool is not inside.
Insertcapsule incapsule holder. Insert capsule holder into
machine.
4
Use touch volume selector to illuminate amountof bars in
accordance withthe numberof bars shownon capsule, or
selectamount of bars to your own taste. Choose XL beverage
foranextra bigcup. Waitaround 1.5 min ifyouwant to pre-
pare a second extra bigcup.
5
Touchhotwatericon (orcold watericon–depending on
beverage). Beverage preparationstarts. Staybeside the
machine throughout the preparation! Bar display lights van-
ishprogressively. Machine stops preparationautomatically.
6
After finishingpreparation bar display flashes and ON / OFF
iconblinks red for about 5 seconds. During thattime do not
tryto pull out the capsuleholder!
7
After extractionis finishedremove cup fromdrip tray.
8
Usedcapsule iconblinks orange until capsule is removed.
Pullout capsule holder. Remove used capsule. Put used cap-
sule in capsule bin.
9
Rinse capsule holder with freshdrinking waterfrom both
sides.Dry capsule holder. Insert it back into machine. Enjoy
yourbeverage!
10
To Next Page
Loading...
