Dome YR-5TT28D - Water Is Not Chilled; Water Does Not Flow through Filter

Page 12 of 14
Fill a jug or large glass of water (at least 600ml) and while holding the
Chilled Water button down, slowly pour the water directly into the top of
the unit. (see below)
The water will slowly drain into the main unit and fill the chiller tank inside.
Continue pouring water into the top until water starts to come out of the
spout under the Chilled Water button. This will indicate the tank inside is
full.
Release the Chilled Water button and replace the Lower and Upper
water tanks onto the top of the unit.
Refill as described previously.
The unit should now work properly.
10.2 Water is not Chilled.
Water has not been given enough time to chill. - While the blue “Cold”
light is illuminated, the water is chilling. When the blue “Cold” light turns
off, the water is chilled. Allow time for the blue “Cold” light to turn off.
Unit is not turned on. – Plug in and switch on. Ensure the switch on the
back of the unit is also switched on.
Do not place the unit in direct sunlight as it will prevent the water from
chilling properly.
10.3 Water does not flow through Filter.
Filter is blocked. - Replace filter.
Refer to note 9.1
Soak filter in clean cold water for 30 minutes prior to using.