Page 9 of 14
• For best performance, and depending on the water temperature, allow
approximately 30 – 40 minutes for the water to chill before use.
• When the water has reached the required temperature, the “Cold” indicator
light will turn off indicating the water in the 600ml chiller tank has fully
chilled.
Note: The Water Chiller Tank has a capacity of 600ml and does not supply
a continuous stream of chilled water.
The unit needs time to chill the replacement water as it enters the chiller
tank as will be indicated by the Blue Indicator Light illuminating.
6 Water Float
• The float is an important part of the Water Chiller. It is used to gauge the
water levels and to prevent overflow.
• To ensure the float is fitted correctly:
o Unscrew the ring nut on the bottom of the
float housing to remove the float.
o The float has a rubber stopper on the tip.
This rubber tip must be pointing upwards
towards the base of the water tank as
shown.
o Tightly screw the ring nut back on the housing.
(Do Not over-tighten)
To Next Page
Loading...