Installing the refrigerator-oven combination RMDT10.5(X)T
26
➤ Make one or more ventilation openings above the oven with a total cross-section
of at least 150 cm
2
.
➤ Fit a panel above the oven and a ventilation grille in the panel with
468 mm x 90 mm (fig. c 1, page 12).
✔ Fresh air enters through ventilation slots into the oven under the door, is heated
and escapes from the oven through ventilation slots in the top of the door
(fig. c, page 12).
I
5.6 Installing the ventilation grill
I
1. Seal the installation frame to make the connection waterproof (fig. e, page 12).
2. Insert the installation frame and screw it down tightly (fig. f, page 12). Use all
the fixing holes for this.
3. Fit the ventilation grill (fig. g 1–2, page13).
4. Insert the slider and lock the ventilation grill with it (fig. g 3, page 13).
5.7 Installing condensation drain
I
NOTE
Check and clean the ventilation holes regularly.
NOTE
Use exclusively original Dometic ventilation grills to ensure safe
operation.
No. in
fig. d, page 12
Description
1Slider
2 Ventilation grill
3 Installation frame
4 Fastening for condensation drain
NOTE
• Condensation can form inside the refrigerator due to frequent door
opening, incorrectly stored food or food that is stored when it is too
warm.
• Condensation must be drained with a constant slope.
To Next Page
Loading...
Need help?
General
