B1600PLUS, B2200, B2600 Operating the roof air conditioner
45
9.8 Adjusting the air nozzles
The air supply within the vehicle can be regulated by setting the air nozzles.
The air nozzles can be regulated by the center knob (fig. 6, page 5).
➤ Align the two diffusers into the desired position (fig. 6, page 5).
➤ Turn the center knob of the slider anti-clockwise.
➤ Move the slider so that the air is led into the desired direction (fig. 7,
page 5).
➤ Tighten the center knob clockwise.
9.9 Replacing the remote control batteries
Replace the batteries if you see the symbol on the display.
The battery compartment is on the back of the remote control.
➤ Gently push down the lid of the battery compartment and slide it open in
the direction of the arrow.
➤ Insert the new batteries (2x type AAA) in the remote control as indicated
in the battery compartment.
➤ Close the cover of the battery compartment.
9.10 Setting the timer
The timer function allows you to set a specific time period for air conditioning.
You can specify the switch-on time, the switch-off time or both values.
The time can be set in 10 minute increments.
I
➤ Before programming the timer, select the air conditioning mode and all
required values (e.g. temperature).
Setting the switch-on time
➤ Press the TIMER button once.
✓ The ON symbol ( ) flashes on the display of the remote control.
➤ Use the + or – button to set the time when the roof air conditioner is to
switch on.
➤ Press the SET button to transmit the value to the roof air conditioner.
NOTE
The remote control returns to its initial mode if no button is
pressed on the remote control for 15 seconds while programming
the timer.
To Next Page
Loading...
