Dometic B59530 - Operating Instructions; Controls; OFF Position ( ); Cooling Operation (Blue Graphic)

12
A. Controls
1. The selector switch has eight positions includ-
ing "OFF". It controls the fan speeds and cooling
modes of operation. See (FIG. 25).
FIG. 25
Colder
Blue Graphic
Cooling
Black Graphic
Fan
2. The thermostat controls the compressor ON/
OFF operation within a temperature range of
approximately 65° F and 90° F measured at the
ADB inlet.
B. "OFF" Position ( )
1. This is to turn unit off.
C. Cooling Operation (Blue Graphic)
1. Turn selector switch to cooling (blue graphic).
2. Set the thermostat at the desired temperature
level.
3. Select the fan speed that best satises your
needs:
a. HIGH COOL: Selected when maximum cool-
ing and dehumidication required.
b. MEDIUM Cool: Selected when normal or av-
erage cooling required.
c. LOW COOL: Selected when room is at de-
sired comfort level and needs to be main-
tained. Normally this speed used for night
time operation.
OPERATING INSTRUCTIONS
The compressor will cycle on and off as
cooling is required to maintain the select-
ed temperature level. The fan runs when
the compressor is off to help keep the
temperature uniform throughout the RV.
 Wait at least 2 minutes before
restarting the compressor when it has been
manually cycled off with either the selector
switch or the temperature set lever. Other-
wise, compressor will quick-cycle and could
result in compressor or supply circuit over-
load.
D. Fan Operation (Black Graphic)
This will circulate the air in your RV without
cooling or heating.
1. Turn the selector switch to fan (black graphic).
There are three positions to select from (high,
medium and low). See (FIG. 25).
E. Center Air Discharge
1. Slide lever to open and close. See (FIG. 26).
FIG. 26
Slide To Open
Or Close