CFF45 Operation
19
7.6 Setting the temperature
➤ Press the “SET” button (fig. 3 4, page 10) once.
➤ Use the “UP +” (fig. 3 7, page 10) and “DOWN –” (fig. 3 6, page 10) buttons
to select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
7.7 Setting the display brightness
The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the display proceed as follows:
➤ Switch on the cooler.
➤ Press the “SET” button (fig. 3 4, page 10) four times.
➤ Use the “UP +” (fig. 3 7, page 10) or “DOWN –” (fig. 3 6, page 10) buttons to
set the brightness of the display.
✓ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✓ The display shows the set mode for several seconds. The display flashes twice
before it returns to the current temperature.
I
7.8 Switching off the cooler
➤ Empty the cooler.
➤ Switch the cooler off.
➤ Pull out the connection cable.
If you do not want to use the cooler for a longer period of time:
➤ Leave the lid slightly open. This prevents odour build-up.
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically reverts to brightness d0
(default). After troubleshooting the set brightness is reactivated.
CFF-45--O-EN-AUS.book Seite 19 Montag, 25. Juni 2018 12:42 12
To Next Page
Loading...
Need help?
General
