Dometic CFX 100W - 7.5 Using the cooler

EN
CFX100W Operation
21
7.5 Using the cooler
A
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
➤ Connect the cooler, see chapter “Connecting the cooler” on page 15.
A
➤ Press the “ON/OFF” button (fig. 3 1, page 10) for between one and two
seconds.
✓ The LED “P” lights up (fig. 3 2, page 10).
✓ The display (fig. 3 5, page 10) switches on and shows the current cooling
temperature.
✓ The cooler starts cooling the interior.
I
Latching the cooler lid
➤ Close the lid.
➤ Press the latches (fig. 2 1, page 9) down, until they latch in place audibly.
I
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
is generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
NOTE
Place the cooler as shown (fig. 1, page 7). If you operate the box in a
different orientation it can be damaged.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED “P” flashes orange.
NOTE – Lid Open Alarm
If the lid is left open for three minutes or more and the device is switched
on, the interior light will flash until the lid is closed.
CFX-100W--O-EN-AUS.book Seite 21 Donnerstag, 13. Juli 2017 10:12 10