Dometic CFX Series - Replacing the Light PCB

EN
CFX28 – CFX65DZ Operation
25
7.15 Replacing the light PCB
➤ Disconnect the power supply to the device.
➤ Pry out the transparent cover with a screwdriver (1).
➤ Unscrew the PCB mounting screws (2).
➤ Pull out the plug from the PCB (3).
➤ Replace the defective light PCB with a new one.
➤ Fit new PCB using reverse of removal instructions.
➤ Press the transparent cover back into the housing.
➤ Reconnect the power supply to the device.
1.
2.
3.
SET
+
–
°
0
CFX-28-CFX-65--O-EN-AUSv2.book Seite 25 Dienstag, 3. April 2018 8:42 08