Cleaning and maintenance CFX28 – CFX65DZ
26
8 Cleaning and maintenance
!
A
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
9 Troubleshooting
WARNING!
Always disconnect the device from the power supply before you clean
and service it.
NOTICE! Risk of damage
•
Never clean the cooler under running water or in dish water.
•
Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
Fault Possible cause Suggested remedy
Device does not
function, LED does
not glow.
No voltage was
detected in the DC
power outlet.
In most vehicles the ignition must be
turned on before power will be supplied
to the DC power outlet.
No voltage present in
the AC power outlet.
Try using another plug outlet.
The device fuse is
defective.
Replace the device fuse, see chapter
“Replacing the AC fuse” on page 24.
The integrated mains
adapter is defective.
This can only be repaired by an
authorised repair centre.
The device does not
cool (plug is inserted,
“POWER” LED is lit).
Defective compressor. This can only be repaired by an
authorised repair centre.
The device does not
cool (plug is inserted,
“POWER” LED flashes
orange, display is
switched off).
Battery monitor is set
too high.
Select a lower battery monitor setting.
Battery voltage is too
low.
Test the battery and charge it as needed.
CFX-28-CFX-65--O-EN-AUSv2.book Seite 26 Dienstag, 3. April 2018 8:42 08
To Next Page
Loading...
Need help?
General
