CF 18, CF 25, CF 35, CF 40, CF 50 Safety instructions
9
• Never pull the plug out of the socket by the cable.
• If the cooling device is connected to the DC outlet: Disconnect the
cooling device and other power consuming devices from the battery
before connecting a quick charging device.
• If the cooling device is connected to the DC outlet: Disconnect the
cooling device or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
• The cooling device is not suitable for transporting caustic materials or
materials containing solvents.
• The insulation of the cooling device contains flammable cyclopentane
and requires special disposal procedures. Deliver the cooling device
at the end of its life-cycle to an appropriate recycling.
2.2 Operating the cooling device safely
!
CAUTION!
• Before starting the cooling device, ensure that the power supply line
and the plug are dry.
A
NOTICE!
• Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for the purpose.
• Do not place the cooling device near open flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
• Danger of overheating!
Ensure at all times that there is a minimum of 50 mm (2") ventilation on
all four sides of the cooling device. Keep the ventilation area free of
any objects that could restrict the air flow to the cooling components.
Do not place the cooling device in closed compartments or areas with
none or minimal air flow.
• Ensure that the ventilation openings are not covered.
• Do not fill the inner container with ice or liquids.
• Never immerse the cooling device in water.
• Protect the cooling device and the cable against heat and moisture.
To Next Page
Loading...
Need help?
General