Operation CoolFreeze
14
This is how to select the battery monitor mode (fig. 1, page 7):
➤ Switch on the cooler.
➤ Press the “SET” button (4) three times.
➤ Use the “+” (6) and “–” (7) buttons to select the battery monitor mode.
✓ The selected mode then appears in the display for a few seconds. The display
flashes several times before it returns to the current temperature.
I
6.10 Switching off the cooler
See fig. 1, page 7
➤ Empty the cooler.
➤ Switch off the cooler: Press the ON/OFF button (1) for three seconds.
➤ Disconnect the plug.
If you do not want to use the cooling device for a longer period of time:
➤ Leave the lid slightly open. This prevents odours from building up.
Battery monitor mode LOW MED HIGH
Cut-off voltage at 12 V
10.1 V 11.4 V 11.8 V
Cut-in voltage at 12 V
11.1 V 12.2 V 12.6 V
Cut-off voltage at 24 V
21.5 V 24.1 V 24.6 V
Cut-in voltage at 24 V
23.0 V 25.3 V 26.2 V
NOTE
When the cooler is supplied by the starter battery, select the battery
monitor mode HIGH. When the cooler is connected to a supply battery,
the battery monitor mode LOW will suffice.
If you wish to operate the cooling device from the AC mains, set the
battery monitor to LOW.
CF11-O-AUS.book Seite 14 Donnerstag, 14. Juni 2018 1:41 13
To Next Page
Loading...
