CoolFreeze Operation
15
6.11 Defrosting the cooling device
Humidity can form frost in the interior of the cooling device or on the evaporator. This
reduces the cooling capacity.
Defrost the device in good time to avoid this.
A
To defrost the cooling device, proceed as follows:
➤ Empty the contents.
➤ If necessary, put them in another cooling device to keep them chilled.
➤ Switch off the device.
➤ Leave the lid open.
➤ Wipe off the condensate.
6.12 Replacing the AC fuse
D
➤ Remove the connection cable.
➤ Pry out the fuse insert (fig. 2 2, page 8) with a screwdriver.
➤ Replace the defective fuse with a new one that has the same rating (T4AL 250 V).
➤ Press back the fuse insert into the housing.
NOTICE! Risk of damage to the device!
Never use hard or sharp tools to remove ice or to free objects frozen
onto the device.
DANGER! Danger of electrocution!
Disconnect the connection cable before you replace the device fuse.
CF11-O-AUS.book Seite 15 Donnerstag, 14. Juni 2018 1:41 13
To Next Page
Loading...
Need help?
General