Using the cooling unit CS-NC15, CS-NCVM
16
Connecting to an AC power supply
!
➤ To operate the cooling unit from the AC power supply, use the rectifier
– CoolPower EPS100 (230 Vw to 24 V
g) for devices with BD35F compressor
– CoolPower MPS35 (110 – 240 Vw to 24 V
g) for devices with BD35F com-
pressor
I
8 Using the cooling unit
8.1 Energy saving tips
•
Choose a well ventilated installation location which is protected from direct
sunlight.
•
Allow hot food to cool down first before placing it in the device.
•
Do not open the refrigerated container more often than necessary.
•
Do not leave the door open for longer than necessary.
•
Defrost the refrigerated container once a layer of ice forms.
•
Avoid unnecessary low temperatures.
•
Clean the condenser of dust and dirt at regular intervals.
•
Clean the lid seal regularly.
WARNING!
•
Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
•
If you are operating your cooling device on board a boat with an AC
power supply from the land, you must install a residual current circuit
breaker between the AC power supply and the cooling device.
Seek advice from a trained technician.
NOTE
The output voltage of the described rectifier is 24 V. Please remember
this when connecting other consumers at a later time.
CS-NC15_CS-NCVM--IO--16s.book Seite 16 Dienstag, 9. Oktober 2018 5:24 17
To Next Page
Loading...
Need help?
General
