EXTREME
COLD
WEATHER
OPERATION
Refrigerator
performance
may
be reduced in extremely
cold
(subzero)
temperatures.
This
temporary condition is
normal for absorption
refrigerators
and does not indicate
product
failure. ln the event that
performance
is reduced
in
such conditions,
turn the refrigerator
off. As ambient
temperatures rise,
please
restart
your
refrigerator
accord-
ing to instructions before requesting service.
CLIMATE CONTROL
SYSTEM
NDM1062
During the summer months of high temperature
and
humidity, the
metal frame
between the freezer and fresh
food compartments may
have
water droplets forming. The
numberof water droplets
will
increase if the vehicle is not
air
conditioned during these months. The refrigerator
comes
standard with a 12 VDC climate
control that
will
evaporate
the water
droplets
when they form. The
climate control can
be
left
on continuously
or
used only
when
temperatures
require it. Note that when turned on, the
climate control
will draw
12VDC
power
continuously.
Turn it
off when a
charging source is
not
available.
[g
1. Turn the climate control switch to I
(ON).
2. Press the CLC button.
The indicator lamp will
illuminate.
OPERATING THE ICE MAKER
NDM1062
WITH
ICE
MAKER
Before
the ice maker can operate,
make
sure that:
.
The refrigerator is
connected
to 120 VAC .
.
The water valve
supplying
the refrigerator is
turned on.
.
The ice level
bail arm
is in its fully
down
position.
lce
level
bailarm
When the ice makerthermostat
senses the
presettempera-
ture
for the
ejection of
the ice cubes, the fingers will
start to
rotate,
dumping any
ice cubes
and
filling
the
mold with
water.
When the
storage container
is full, the bail
arm
will
come
in
contact with the ice cubes. The bail arm cannot return
to
the full down
position
and
the ice
production
is stopped
untilthe
bin is emptied, or
ice cubes
are
removed.
To
prevent
water from splashing out of the
mold
assembly
while
travelling in
your
recreational vehicle, raise
the bail
arm to
the full UP/OFF
position
aboul l-112 hours
before
departing. This will allow the
water in the mold to freeze.
WATER
SUPPLY
The water
supply system
must have a minimum
pressure
of
15
pounds per
square
inch
gauge
(psig).
4114" diame-
ter water
line to the
water valve should be used at the rear
of the refrigerator. The
water line must have a manual
shutoff valve
placed
where it is easily accessible.
The
maximum water
level is represented by a thin
line. lt
is
essential that the
water level does not exceed this
line!
lf necessary,change
the water
flow
by adjusting the
water
supply. For instructions, see ADJUSTING
THE
SIZE OF
CUBES.
The Climate control
switch is
located
be-
neath
the top decora-
tion
panel
that houses
the control
panel.
To Next Page
Loading...
