Check List
13
5.8
Failure : No cooling (the aggregate at the back of the device is cold).
Possible Cause Self Help Authorised Service
a.) The device plug is not
plugged in.
b.) No voltage in socket.
c.) The electronics or the sensor
is faulty.
Does the LED flash ?
d.) Defective heating element.
e.) The device is in its defrosting
phase.
a.) Plug in device plug.
b.) Check main fuse.
e.) See operating instruction
5.3
c.) Install new
electronics or sensor.
d.) Install new heating
element.
Failure : No cooling (the aggregate is warm).
Possible Cause Self Help Authorised Service
a.) The device is not level.
Leakage test ?
b.) The device was only
switched on a short while
ago.
c.) Defective cooling unit.
a.) Level the device using a
spirit level.
b.) Switch on the device and
let it run for 5-6 hours.
c.) Exchange device.
Failure : Poor cooling performance.
Possible Cause Self Help Authorised Service
a.) The cooling aggregate is not
sufficiently ventilated.
b.) The device is exposed to
direct sunlight.
c.) The fridge door does not
close tightly
d.) The fridge was stocked a
short while ago.
a.) Check that the ventilation
grids are not covered.
Check that device has
been installed properly
(installation instruction 4.5).
b.) Follow installation
instruction 4.5.
c.) Check installation in line
4.5 + 4.8 .
d.) Check fridge after
5-6 hours for proper
cooling function.
c.) Install new doorseal,
if necessary.
Failure : Frost formation in fridge.
Possible Cause Self Help Authorised Service
a.) The fridge door does not
close tightly.
a.) Check installation is in line
with 4.5 + 4.8.
a.) Install new doorseal,
if necessary.
To Next Page
Loading...
Need help?
General
