EasyManuals Logo

Dometic MasterFlush 7600 Series User Manual

Dometic MasterFlush 7600 Series
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
EN
MasterFlush 7600 Series Toilet Maintenance
7.2 Flushing the Toilet
NOTICE: Flush only water, bodily wastes, and rapid-
dissolving toilet tissue. Do not flush foreign objects. Do
not flush wet wipes, sanitary napkins, diapers, paper
cups, cotton swabs, food, hair, or liquids such as oils or
solvents. Failure to follow these instructions could cause
clogging or damage to the toilet or the toilet system.
q
12 Flushing the Bowl
q
Flush Bowl
1. To flush, press the flush pedal down completely.
2. Release the pedal.
This activates a powerful macerator pump that siphons
the water and waste from the toilet bowl, and then
macerates and propels the effluent to the holding tank.
I
Residual water trickle in ceramic bowls: due to
the integrated rim of this toilet bowl, water may
continue to slowly trickle into the toilet bowl for
up to 20 minutes aer flushing. If the water trickle
continues aer 30 minutes, replace the water valve.
7.3 Changing the Flush Settings
This section describes two flush settings offered to help
manage water usage and how to apply each setting.
7.3.1 Normal Flush
I
The normal flush setting uses 0.8 gal (3 L) per flush
and adds water to the bowl aer every flush.
To change the flush setting from dry bowl to normal
flush, press the flush pedal for ten seconds.
7.3.2 Dry Bowl Flush
I
The dry bowl flush setting uses 0.2 gal. (0.8 L) per
flush and does not add water to the bowl.
To change the flush setting from normal to dry bowl,
press the flush pedal for approximately ten seconds.
7.4 Understanding the Full Tank
Indicator
I
If an optional tank monitor is not installed, skip to
“Maintenance” on page11.
When an optional tank monitor system is installed
and operational, a solid red indicator light on the tank
monitor control panel will indicate the holding tank is
full. Flushing will be disabled to prevent overfilling the
holding tank.
To restore electrical power to the toilet for flushing,
empty or discharge the holding tank contents until the
indicator is off. Additional features and indicators may be
available based on the tank monitor model.
8 Maintenance
This section describes recommended cleaning and
maintenance procedures.
8.1 Cleaning
NOTICE: Do not clean the toilet with abrasive cleaners,
caustic chemicals, or lubricants and cleaners that contain
alcohols or petroleum distillates. Using them could
cause damage to internal seals.

Table of Contents

Other manuals for Dometic MasterFlush 7600 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dometic MasterFlush 7600 Series and is the answer not in the manual?

Dometic MasterFlush 7600 Series Specifications

General IconGeneral
BrandDometic
ModelMasterFlush 7600 Series
CategoryToilets
LanguageEnglish

Related product manuals