MCS T6, MCS T12, MCS T16 Operating
11
➤ Press and hold the Fan Button during normal operation to select one of the six
manual fan speeds available.
Circulation Mode
When the system is off at the control panel the fan can be used to only circulate the
air.
➤ Press and hold the Fan Button when the display is off until the desired speed
number appears in the window.
➤ Release the Fan Button.
✓ The fan will run at the selected speed circulating the air without heating or
cooling.
➤ Press the Power Button once to cancel the Circulation Mode and enter the On
Mode.
Dehumidification Mode
➤ While in the On Mode simultaneously press the Power and Down Buttons.
✓ The first cycle will start in one minute.
➤ Press the Power Button to end the Dehumidification Mode.
✓ The “HU1” mnemonic code is displayed while in the Dehumidification Mode.
Program Mode
I
The Program Mode is used to adjust the systems operating parameters to suit the
particular needs of individual users. The Program Mode is also used to tailor the air
conditioning system for the most efficient operation within an installation.
Variables such as ducting, sensor location and system layout affect the system oper-
ation. The Marine Climate System is shipped with factory default settings which are
stored in permanent memory and can be recalled at any time.
NOTE
The program mode can only be entered from the Off Mode.
MCS-6-12-16--O-West.book Seite 11 Dienstag, 14. November 2017 11:28 11
To Next Page
Loading...
Need help?
General
