MCS T6, MCS T12, MCS T16 Warranty
35
•
Use of the seawater pump to pump anti-freeze solution through the system and
discharging through the overboard thru-hull fitting until all water is flushed out
and the solution no longer appears diluted:
– Close seacock.
– Remove hose from strainer discharge.
– Raise hose above pump (so pump does not lose its prime).
– Pour in antifreeze solution.
– Pump solution through system.
– Drain the strainer and hose to seacock of water.
•
Use of pressurized air injected at the overboard discharge fitting and the water
being discharged through the seawater intake fitting.
•
Use of pressurized air to force water from the intake through the overboard dis-
charge.
Any method that causes the antifreeze solution to flow downward is the method of
choice. By this means, the antifreeze solution will displace any water trapped and
eliminate the possibility of freezing in hidden areas.
In addition, since the seawater pump utilizes a magnetically driven impeller:
•
Remove the impeller from the wet end assembly.
•
Wipe the impeller with an alcohol solution.
•
Store the impeller in a warm, dry area until commissioning takes place.
11 Warranty
The statutory warranty period applies. If the product is defective, please contact the
service partner in your country (addresses on the back on the instruction manual).
Our experts will be happy to help you and will discuss the warranty process with you
in more detail.
12 Disposal
➤ Place the packaging material in the appropriate recycling waste bins wherever
possible.
M
If you wish to finally dispose of the product, ask your local recycling centre
or specialist dealer for details about how to do this in accordance with the
applicable disposal regulations.
MCS-6-12-16--O-West.book Seite 35 Dienstag, 14. November 2017 11:28 11
To Next Page
Loading...
Need help?
General
