MCS T6, MCS T12, MCS T16 Programming
15
To view the service history log proceed as follows:
➤ Turn off the AC power.
➤ Press the Fan Button and hold it.
➤ Turn on the AC power.
➤ Once Power On Reset is completed (display indicates “888” and all LEDs are lit)
release the Fan Button.
✓ The display will flash the most recent fault detected, followed by the event chro-
nology number.
➤ To view other events detected press either the Up or Down Button.
➤ To clear the service history log simultaneously press the Power and Down But-
tons.
➤ To exit the service history log
– press either the Power, the Up or the Down Buttons or
– wait thirty seconds without pressing any button.
8Programming
8.1 Entering Program Mode
➤ Press and hold the Power Button while in the Off Mode until the letter “P”
appears in the display.
✓ The characters “P1” followed by the parameter setting, appear in the display.
✓ The Marine Climate System is now in the Program Mode.
I
8.2 Changing Program Parameters
➤ Increment from one program parameter to the next by pressing the Fan Button.
➤ Press the Up and Down Buttons to select the data or set the desired limits for the
parameter being programmed.
NOTE
The Marine Climate System will exit the Program Mode and return to the
Off Mode if no programming is attempted for one minute.
MCS-6-12-16--O-West.book Seite 15 Dienstag, 14. November 2017 11:28 11
To Next Page
Loading...
Need help?
General
