Programming MCS T6, MCS T12, MCS T16
16
8.3 Saving New Program Parameters
I
➤ Simultaneously press the Up and Down Buttons to save the new program param-
eters.
✓ This will set the new program defaults.
8.4 Exiting the Program Mode
There are two methods to exit the Program Mode.
➤ Press the Power Button
✓ The Marine Climate System will return to the Off Mode.
… or
➤ Do not press any buttons and do not attempt any program changes for one
minute.
✓ The Marine Climate System will exit the Program Mode.
8.5 Software Identification
The software version of the Marine Climate System is identified for one second prior
to the exit from the Program Mode. The software identification number, e.g. (“A12”)
will appear in the display for one second, then the Marine Climate System will return
to the Off Mode.
I
NOTE
Factory defaults shown in the “Programmable Parameters Table” on
page 17 may be reset manually (see “Restore Memorized Default Set-
tings” on page 17).
NOTE
Should there be any reason to contact Dometic about the system or pro-
gramming the Marine Climate System be sure to have the software iden-
tification number and air conditioning unit serial number available. The
serial number may be found on the typeplate.
MCS-6-12-16--O-West.book Seite 16 Dienstag, 14. November 2017 11:28 11
To Next Page
Loading...
Need help?
General
