10
To remove the refrigerator:
1. Remove the screws anchoring the refrigerator
to the enclosure.
2. Slide the refrigerator out of the compartment.
To replace the refrigerator:
1. Make sure the sealing strips (isolating the appli-
ance combustion system from the vehicle interior)
are properly positioned for a complete seal.
2. Slide the refrigerator back into the compartment.
3. Replace the screws anchoring the refrigerator
to the enclosure.
4. Reconnect the LP gas supply line at the rear of
the refrigerator.
REFRIGERATOR REMOVAL
Refrigerator removal and installation should be
performed by a qualied service technician.
Before removing the refrigerator:
1. Verify that the 120 VAC power cord is discon-
nected at rear of refrigerator.
2. RM2510: Verify that the 12 VDC leads are discon-
nected and capped at rear of refrigerator.
3. Shut off the gas supply.
4. Disconnect and cap the LP gas supply line at
rear of refrigerator.
Always use a backup wrench when loosening
and tightening LP gas connections.
Always use a backup wrench when loosening
and tightening LP gas connections.
5. Check all connections for LP gas leaks.
6. Reconnect the 12 VDC leads at rear of refrig-
erator.
7. Reconnect the 120 VAC power cord at rear of
refrigerator.
To Next Page
Loading...
Need help?
General
