Dometic RTX1000 - Setting the Temperature; Setting the Mode

EN
Using the parking cooler CoolAir RTX1000, RTX2000
18
7.7 Setting the temperature
I
Control panel
➤ Press the button until the symbol is displayed.
➤ Press the or button to set the desired temperature.
➤ Press the button to save the value.
Remote control
➤ Press the + button to increase the temperature.
➤ Press the – button to decrease the temperature.
➤ To save the value don‘t press any button for more than 5 seconds.
7.8 Setting the mode
Control panel
➤ Press the button until the symbol is displayed.
➤ Press the or button to set the AUTO, ECO or BOOST mode.
To set the MANUAL mode see below.
➤ Press the button to start the selected mode.
If you like to set the fan speed manually (MANUAL mode):
➤ Press the button until the symbol is displayed.
➤ Press the or button to set the desired fan speed. At the same
time the MANUAL mode is started.
➤ Press the button to save the value.
NOTE
Depending on the set unit for the temperature, the temperature is
changed in steps of either 1 °C or 2 °F.