CoolAir RTX1000, RTX2000 Technical description
9
5 Technical description
The parking cooler can be used for conditioning inside the vehicle. The air in
the interior is guided into the system through the intake grille, cooled, dried
and conveyed back into the interior through the blower nozzles.
In BOOST mode, the parking cooler cools the vehicle interior for not more
than 20 minutes at maximum power and then switches to AUTO mode.
When the set temperature is reached, the parking cooler switches to AUTO
mode before the 20 minutes is reached.
In AUTO mode, the fan and compressor speed are controlled automatically.
In ECO mode the fan and compressor speed are controlled automatically.
The compressor power is limited in ECO mode electronically.
The system is controlled using the control panel or the remote control.
I
The system is fitted with a battery monitor. If the system is operated when the
vehicle ignition is switched off, the system switches off automatically as soon
as the supply voltage falls below a set level.
I
NOTE
The parking cooler can lower the temperature within the vehicle
to a certain level. The temperature depends on the type of vehicle,
the ambient temperature and the cooling capacity of your parking
cooler. For the cooling capacity of your parking cooler, chapter
“Technical data” on page 26.
NOTE
This set level can be changed. For this, please contact the
specialised company that installed the system.
To Next Page
Loading...
