Dometic RTX1000 - Page 23

EN
CoolAir RTX1000, RTX2000 Display messages
23
8.2 Control panel fault messages
The “ERROR” symbol (fig. 4 5, page 4) lights up if there is a fault with the
parking cooler. The type of error is shown on the display by the following error
codes:
Display
text
Description Cause Remedy
F01
The compressor does
not work.
Error in compressor
sensor electrical supply
(open circuit).
➤ Switch off the system.
➤ Switch it on again after
30 minutes.
➤ If the fault occurs again,
contact an authorised
workshop.
F02
Error in compressor
sensor electrical supply
(short circuit).
F03
Compressor overload
F04
The condensor fan 1
does not work.
No response from the
fan.
F05
The condensor fan 1 is
overloaded.
Faulty fan speed
F06
The condensor fan 2
does not work.
No response from the
fan.
F07
The condensor fan 2 is
overloaded.
Faulty fan speed
F08
The evaporator fan does
not work.
No response from the
fan.
F09
The evaporator fan is
overloaded.
Faulty fan speed
F10
––
F11
The system cannot
determine the internal
temperature.
Error in temperature
sensor electrical supply
(open circuit).
F12
Error in temperature
sensor electrical supply
(short circuit).