Dometic RTX2000 - P.02 Temperature Display Unit; P.05 Tilt Sensor Calibration

15
EN
RTX1000/2000, SPX1200T Configuring the system software
7.3 P.02: Unit for temperature display
The system can display the room temperature in °C or °F.
➤ Switch to configuration mode (chapter “Entering and exiting configuration
mode” on page 13).
✓ The display shows “P.01” and the symbol flashes.
➤ Press the or button to select the menu item P.02.
✓ The display shows “P.02” and the symbol lights up.
➤ Press the button to change the setting.
✓ The code for the current setting is displayed:
– 0: °C
– 1: °F
➤ Use the or button to select the desired temperature unit.
➤ Press the button to save the setting.
✓ The set value is saved and is then applied when the system is restarted.
✓ You are then returned to the menu and can select another menu item by
pressing the or button.
7.4 P.05: Tilt sensor
The electronics of the system prevents that the system is switched on when the
vehicle is parked at a slope. Since some vehicles‘ roof already is tilted, the tilt
sensor has to calibrated to the zero setting before first use.
➤ Park the vehicle on a level place.
➤ Switch to configuration mode (chapter “Entering and exiting configuration
mode” on page 13).
✓ The display shows “P.01” and the symbol flashes.
➤ Press the or button to select the menu item P.05.
✓ The display shows “P.05”.
➤ Press the button to change the setting.
✓ The code for the current setting is displayed.
➤ Use the or button to select “1”.
➤ Press the button to save the setting.
✓ The set value is saved and is then applied when the system is restarted.
✓ You are then returned to the menu and can select another menu item by
pressing the or button.
57;63;7,YHFR,VERRN6HLWH)UHLWDJ'H]HPEHU