Cleaning and maintenance
NOTICE! Damage hazard
Never clean the cooler under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during cleaning as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and dirt, so that heat can be released and the device is not damaged.
Warranty
The statutory warranty period applies. If the product is defective, please contact the manufacturer’s branch in your country (see dometic.com/dealer) or your retailer.
For repair and warranty processing, please include the following documents when you send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
Troubleshooting
Problem Possible cause Suggested remedy
Your device is not working (plug is inserted).
The inner fan or the cooling element is defective.
The ignition must be switched on in most vehicles to
apply current to the DC socket
The inner fan or the cooling element is defective. This can only be repaired by an authorized repair center
When operating from the DC socket:
The ignition is on and the cooling device is not working.
The fuse of the DC plug is dirty. This results in a poor
electrical contact.
If the plug of your cooling device becomes very warm in
the DC socket fitting, either the fitting must be cleaned
or the plug has not been assembled correctly.
The fuse of the DC plug has blown.
Replace the fuse (fig. ) of the DC plug with one of
the same rating.
The vehicle fuse has blown.
Replace the vehicle’s DC socket fuse (usually 15 A).
Please refer to the operating manual of your vehicle.
To Next Page
Loading...
Need help?
General
