To Next PageTo Next Page
Need help?Do you have a question about the Dometic SKE 180 and is the answer not in the manual?
General| Brand | Dometic |
|---|---|
| Model | SKE 180 |
| Category | Refrigerator |
| Language | English |
Compares Face-lifting, Greenline, and Previous models, noting energy savings and key feature changes between generations.
Controls temperature using electronic intelligence for energy saving, maintaining constant levels without interrupting cooling unit operation.
Utilizes two sensors for leak detection and performs self-tests, indicating status via heating element duty-cycle after power-on-reset.
Procedure for measuring heating shell resistance to identify faults, listing resistance values for different voltage/wattage configurations.
Step-by-step instructions for changing light bulbs, including unplugging the unit, removing the reflector, and inserting a new bulb.
Procedure for replacing bulbs in specific models, involving unplugging, reflector removal, and bulb replacement.
Emphasizes level installation, 20mm wall clearance, specific ventilation dimensions, duct size, cooling unit projection, and avoiding preheating.
Table providing recess dimensions (Height, Width, Depth) in millimeters for various Dometic miniBar models.
Defines required clearances: 1-2mm for the cupboard door against surrounding areas and 6-8mm between the door and the miniBar.
Explains how the mechanical ADC indicates door opening via a red dot and provides reset instructions for RH456LD/E and other models.
Details the procedure for exchanging the complete mechanical ADC component, which is inserted into the doorframe without requiring screw removal.
Information on retrofitting electrical ADC to specific miniBar models, listing necessary service-kits and their part numbers.
Initial steps for mounting the electrical door control system, including unplugging, hinge removal, and attaching the magnet and distance plates.
Continuation of mounting steps for electrical ADC, involving drilling, sensor fixing, terminal strip installation, and cable connection.
Steps for mounting the electrical door control on the miniBar's underside, focusing on positioning the sensor and magnet.
Final steps for electrical ADC installation, including mounting the terminal strip, connecting sensor cables, and adjusting feet for 8mm high units.
Outlines warranty terms, excluding damages from improper use, modifications, non-original parts, or failure to follow instructions.
Troubleshooting steps for when the cooling unit is cold but cooling is absent, focusing on heating shell, sensors, and electronic faults.
Troubleshooting steps for 'No cooling' with a warm unit, addressing appliance leveling, ventilation, and potential cooling unit failure.
Details technical specifications for models RH430LD through RH448D, covering casing, volume, dimensions, power consumption, and net weight.
Explains how to set and adjust the cold-storage temperature in HiPro compartments using the remote control for Europe and USA.
