MD310, MD390, MD450 Installing safe
7
7 Installing safe
7.1 Notes on installation
A
Follow the instructions when installing.
•
Carefully check the safe for damage once you have removed it from the
packaging. If there is visible damage, contact the manufacturer (see rear of safe
for addresses).
•
Install the safe on a flat and even surface.
•
Select a location for installation which is a sufficient distance from heat sources
(e.g. radiators). Avoid installing in locations with temperatures of under 0 °C and
over 45 °C.
•
Avoid damp ambient conditions (e.g in the bathroom and swimming pool) in
order to avoid condensation forming in the device.
•
Select a fastening material (screws with plugs, if necessary) which is appropriate
for the base.
7.2 Attaching the safe
➤ Select a suitable installation location.
➤ Select an appropriate method for installation (attachment on the rear or on the
underside).
➤ Mark the drill holes according to the table below
Drilling on the rear (fig. 2, page 2)
NOTICE!
The safe must only be installed by qualified specialists.
Model MD450 MD390 MD310
H 100 mm 100 mm 82.5 mm
L1 120 mm 90 mm 50 mm
L2 210 mm 210 mm 210 mm
XSafe-IO.book Seite 7 Dienstag, 13. August 2019 2:03 14
To Next Page
Loading...
