Dometic TEC29 - Preparing Maintenance Work; Finishing Maintenance Work

EN
TEC29, TEC29LPG Servicing the generator
25
10.2 Preparing maintenance work
!
➤ Switch the generator to no function with the main switch (fig. 4 1, page 5).
➤ Disconnect the positive terminal of the supply battery.
➤ Open the generator front door.
For maintenance work, you can take the generator out (fig. 5, page 5):
!
➤ Undo the fastening screws (1).
➤ Remove the mounting plate (2) with the generator from the housing (3).
10.3 Finishing maintenance work
➤ Connect the generator to the positive terminal of the supply battery.
➤ Switch the generator to standby with the main switch (fig. 4 1, page 5).
➤ Close the generator front door.
CAUTION!
Note the following for all maintenance work:
• The generator must not be running.
• All the parts must be cooled down.
WARNING!
The mounting plate with generator is very heavy (> 40 kg) and could fall
out the housing if you take it out too far.
TEC29-B-16s.book Seite 25 Donnerstag, 21. Juli 2016 8:09 08