INSTALLATION INSTRUCTIONS
2-22 L025317 Issue 5 July 2014
This pin offers the positive supply input of all output opto couplers.
Pin J PRINTER_READY - Laser Ready to Print DC output
This output opto coupler is switched on when the printer is ready to print. In
multi head systems this pin shows the logical “AND” result of all
Printer_Ready signals in the chain.
Pin K PRINTER BUSY - Print busy DC output
This output opto coupler is switched on while the print is processed. In
multi head systems this pin shows the logical “OR” result of all Printer_Busy
signals in the chain.
Pin L COMPILE_OK - Compile ok DC output
This output opto coupler is switched on when the compilation of the next
print data is finished. In multi head systems this pin shows the logical
“AND” result of all Compile_OK signals in the chain.
Pin M NC - Not connected
Inputs:
10-30V, NPN, PNP
Input Impedance: 1 kOhm
Outputs
Solid State Relays
max. Voltage: 50V
max. Current X4 and X28 : 0.5A
To Next Page
Loading...
Need help?
General
