EPT076596 Issue 1 – March 2022
10
Safety Instructions
Warning and Information labels
The following listing details labels used on your DPX3500 unit.
Goggles, Gloves & Mask Label
Meaning: Goggles, Gloves and Masks should be worn while
handling used filters and refer to the user manual.
Electrical Danger
Meaning: Removal of panels with this label attached will allow
access to potentially live components.
Warning Label
Meaning: Power should be isolated before the panel with this label
attached is opened/ removed.
Heavy item Label
Meaning: Best practice manual handling to be used when lifting
this item, refer to customer risk assessment.
Manufacturer address
Meaning: The address of which the product was manufactured, the
location of this symbol is found on the marking plate.
Fire Risk Warning
In the very rare event that a burning ember or spark is drawn into
the fume extraction unit, it may be possible that the particulate
within the filters will ignite.
Whilst any resultant fire would typically be retained within the
fume extraction unit, the damage to the extractor could be
significant. It is therefore essential to minimise the possibility of
this occurring by undertaking an appropriate Risk assessment to
determine:
a). Whether additional fire protection equipment should be
installed.
b). Appropriate maintenance procedures to prevent the risk of
build-up of debris which could potentially combust.
This unit should not be used on processes where sparks could
occur, with explosive dusts and gases, or with particulates which
can be pyrophoric (can spontaneously ignite), without
implementation of additional precautions.
It is essential that nozzles or other extraction/ fume capture
devices and hoses/pipework are cleaned regularly to prevent the
build-up of potentially ignitable debris.
Application environment
The DPX3500 Laser Extraction System is intended for a permanent
installation within a manufacturing site and in areas similar to
manufacturing sites.
The DPX3500 Laser Extraction System must be installed in areas
that comply with the following environmental conditions:
• Indoor and is not subjected to weathering
conditions.
• The installation room must be equipped with
suitable room ventilation to disperse any residual
exhaust gases.
To Next Page
Loading...
Need help?
General
