Why does my Domino Printer show a 'Speed Limit' error?
If your Domino Printer displays a 'Speed Limit' error, it means the encoder is measuring a speed that's too fast. Unfortunately, the printer cannot function at this speed.
What to do if my Domino Printer shows 'VDC/Real Time Printing Speed Overload'?
If your Domino Printer shows a 'VDC/Real Time Printing Speed Overload' error, you should either slow down the production line or move the product detect sensor further from the print head.
What does 'Ink Out' mean on my Domino Printer?
If your Domino Printer displays an 'Ink Out' message, it indicates that the ink level in the cartridge is critically low, specifically below 0.4 ml.
What does 'Ink Low' mean on my Domino Printer?
If your Domino Printer displays an 'Ink Low' message, this means that the ink level in the cartridge is below 5 ml.
General| Series | G Series |
|---|---|
| Power Requirements | 100-240VAC, 50/60Hz |
| Type | Industrial inkjet printer |
| Capacity | Varies by model |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Compliance | CE, UL, CSA |
Describes the manual's purpose and scope for installation, operation, and recycling.
Emphasizes the importance of reading and acting upon safety information and symbols.
Details the controller's ports, buttons, and status indicators.
Details the print head's ports, buttons, and status indicators.
Describes the printer's 5-inch touch screen interface for setup and operation.
Step-by-step instructions for mounting the G50i printer vertically.
Step-by-step instructions for mounting the G50i printer horizontally.
Procedure for connecting the print head to the controller.
Steps for correctly installing an ink cartridge into the print head.
Instructions for connecting the printer's power adapter.
Configuration options for print quality parameters like resolution and channel.
Adjusting print head alignment parameters such as offsets.
Setting up internal or external encoder input for speed measurement.
Setting up continuous and sensor-based print triggering modes.
Managing user access, permissions, and passwords for the printer.
Configuring IP address, subnet mask, and gateway for network connectivity.
Steps to power on and initialize the printer.
Guide to creating and setting up new label templates.
Adding various elements like text, counters, barcodes, and graphics.
Procedures for saving and managing label templates.
Explanations of common printer error messages and their causes.
Troubleshooting common issues affecting print quality.
Procedure for updating the printer's software and firmware.
Step-by-step guide to replace the ink cartridge.
Procedure for cleaning the print head assembly.
Procedure for cleaning the printer controller unit.
To Next Page
