EN
MAINTENANCE
Regular maintenance is necessary to maintain the performance of your machine and extend its life.
Failure to follow maintenance instructions may lead to premature wear or permanent damage, and result in the cancellation of the commercial warranty.
For any questions, contact your DECATHLON store or visit our website www.domyos.com.
MAINTENANCE AFTER EACH USE
As perspiration is corrosive, it is crucial to wipe down your treadmill after each use.
1. Switch off and unplug your treadmill.
2. Apply a small amount of a mild cleaning agent onto a 100% cotton cloth. Do not spray the cleaner directly onto the treadmill and do not use cleaners
containing ammonia or acid.
3. Wipe down the console and screens.
4. Remove dust and stains on the ramps, support, footrests, frame and motor cover. Also wipe the platform along the entire running belt. Do not clean
under the running belt.
For information on purchasing a cleaner, please contact your local DECATHLON store.
WEEKLY MAINTENANCE
1. Inspect and, if necessary, tighten all external parts of the treadmill.
2. Make sure the running belt is centred and properly tightened.
Adjusting the position of the treadmill belt (centring):
The space G between the treadmill belt and the footrests must be visible at all times on
both sides of the treadmill belt. This prevents damage to the treadmill belt and untimely
stopping.
• Run your treadmill at 5kmph (3mph) and stand behind the machine.
• The belt is o -centre to the left:
Turn the left adjustment screw half a turn in a
clockwise direction.
• The belt is o -centre to the right:
Turn the right adjustment screw half a turn in a
clockwise direction.
• Let the treadmill run long enough for the belt to reposition itself (1 or 2 minutes) and
repeat the procedure if necessary. However, make sure that the belt is not too tight.
Adjusting the tension of the treadmill belt:
The treadmill belt is a part subject to wear and tear which slackens over time. Re-tighten it as soon as it begins to slip (skidding feeling with sudden changes
in speed).
1. Turn both adjusting screws half a turn clockwise.
2. Repeat the procedure if necessary but be careful not to over-tighten the belt. The belt is correctly tightened if you can lift the edges by 2 to 3
centimetres on each side.
MAINTENANCE EVERY 200 HOURS OF USE OR EVERY 1500 KM
To nd out the duration of use and the distance travelled since the treadmill was started up, refer to the INFORMATION MODE section.
Lubricating the treadmill belt:
It is advisable to lubricate your belt in order to reduce friction between the treadmill belt and the deck. Lubrication is not necessary if traces of silicone are
present on the inner side of the treadmill belt or on the deck (a wet and slightly greasy surface).
If the belt and deck are dry:
1. Switch off and unplug your treadmill.
2. Raise the edges of the belt and coat the inner side with silicone spray.*
3. Plug your treadmill back in.
4. Let the treadmill run on its own at 4 kmph (2.5 mph) for 10 to 20 seconds.
5. Your treadmill is ready to use!
*One lubrication usually requires between 5 and 10ml of silicone.
Important: too much silicone may hinder the performance of your treadmill (risk of sliding).
For information on purchasing a cleaner, please contact your local DECATHLON store.
To Next Page
Loading...
Need help?
General
