DongFeng Nammi 01 - Page 68

-
68
-
Before Driving
2
Vehicle Charging
Discharging Methods*
Using a self-purchased power strip
discharge connector to achieve external vehicle
discharge, the maximum external discharge
power is 3.3kW.
Vehicle to Power Strip Discharge
Connection Device:A charged vehicle can use
a power strip to supply electricity for charging
devices such as mobile phones, computers, etc.
CAUTION
● When the vehicle's external discharge
reaches the discharge limit, it will stop
discharging.
● It is recommended to unplug the device
when not in use to avoid high static
power consumption.
● Before using the vehicle's external
discharging function, the high-voltage
system of the vehicle needs to be
checked, which may affect the discharge
response time.
● Before using the vehicle's external
discharge function, confirm that the
external appliance's power is less than
3.3 kW. For some appliances with higher
starting power (such as air conditioners),
the starting process may trigger the
vehicle's discharge function's over-
power protection, resulting in abnormal
discharge function.
Pre-Discharge Check
Activating Discharge Function
Please purchase a power strip discharge
connection device on your own and ensure that
the discharging device is free from scratches,
rust, cracks, or damage to the gun, cable, socket,
and the surface of the wires.
Do not discharge if the socket surface is
damaged, rusted, cracked, or the connection is
too loose.
When the plug is dirty or damp, disconnect
the power rst and wipe the plug with a dry clean
cloth to ensure that the discharge plug is dry and
clean.
1. Before discharging, ensure that there are no
faults in the high voltage of the vehicle, and
switch the vehicle power to “ON” mode;
2. Unlock the vehicle, press the rear part of the
charging port cover, and open the cover;
3. Remove the dust cover from the AC charging
port;
4. Press the release button on the discharge
cable connector, remove the protective cover;
5. Insert the discharge plug into the vehicle's
discharge socket until a click is heard;
6. Press the switch on the discharge socket and
wait a few seconds, then the socket indicator
light stays on (red), indicating the socket is
ready for use.
NOTE
● Please use this function when the power
battery capacity is sufcient.