-
69
-
Before Driving
2
Vehicle Charging
CAUTION
● To prevent malfunction of the electric
charging port cover, do not repeatedly
open and close the cover continuously.
WARNING
!
● Do not use this function if the protective
packaging or discharge port is
disconnected, cracked, open, or shows
any damage.
● Do not allow minors to touch or use this
device, and keep them away during use.
● Immediately stop using the device if there
is any abnormality during discharging.
● Do not touch the plug with wet hands.
● Do not touch the discharge plug pins and
the vehicle's discharge socket.
● Do not use this device if the three-
phase plug wire becomes soft, or if
the discharge gun cable is worn, the
insulation layer is cracked, or there are
any other damages.
● When using the vehicle's external
discharge function, do not place the
discharge power strip in a damp
environment to avoid rainwater falling on
the strip.
1. Unplug the device from the socket, press the
switch button, and the socket indicator light
goes out;
2. Unlock the vehicle, press and hold the release
button, disconnect the discharge cable
connector and cover it with the protective cap,
then properly store the discharge equipment;
3. Please ensure the dust cover and charging
port lid are properly closed.
Stopping the Discharge Function
NOTE
●
When stopping discharging, ensure that
the time interval between unplugging
and replugging the discharge gun is ≥
3s.
Discharge Trouble Diagnosis
Discharge Energy Management
Possible reasons for the vehicle not
discharging:
● The temperature of the power battery is
below -20
℃
or above 45
℃
.Allow the power
battery to heat up or cool down before
discharging, and place the vehicle in a
suitable temperature environment until the
temperature normalizes before discharging;
● Insufcient power battery charge.
In the “Energy” interface of MP5, you can
view the discharge status and set discharge
limits.
Tap “Discharge” to enter the discharge
settings interface:
● The MP5 Energy→Discharge interface
displays the vehicle status (discharge status,
range, battery charge, discharge gun insertion
status).
● You can set discharge limits (the lowest
discharge limit will not be less than 20%) and
end discharging.
To Next Page
Loading...
